Synthesis, structural characterization, and application prospects of SiO2/CaCl2 composite materials for atmospheric water harvesting
DOI:
https://doi.org/10.54939/1859-1043.j.mst.111.2026.71-78Keywords:
Atmospheric water harvesting; SiO₂/CaCl₂ composite; Sol–gel synthesis; Water vapor adsorption.Abstract
In this study, SiO₂/CaCl₂ composite materials were synthesized via a sol–gel method for atmospheric water harvesting applications. The effects of the SiO₂/CaCl₂ mass ratio and gel aging time on structural characteristics and adsorption performance were systematically investigated. The optimal synthesis conditions were identified at a SiO₂/CaCl₂ mass ratio of 1:1 with a gel aging time of 48 h. Structural properties of the synthesized composites were characterized using SEM–EDX, X-ray diffraction (XRD), and N₂ adsorption–desorption (BET) analysis. The results revealed a biphasic structure consisting of crystalline CaCl₂ dispersed within an amorphous SiO₂ matrix, with a specific surface area of 19.1 m² g⁻¹ and mesoporous characteristics. At room temperature (25–27 °C), the composite exhibited water adsorption capacities of 0.31 g g⁻¹ at 70% relative humidity (RH) and 0.39 g g⁻¹ at 90% RH, reaching equilibrium after approximately 60 h. Although a decrease in adsorption capacity was observed after thermal regeneration, the material retained considerable water uptake, demonstrating its potential for low-cost, decentralized atmospheric water-harvesting systems.
References
[1]. C. Zhang et al., “Atmospheric Water Extraction – A Review from Materials to Devices”, Journal of Materials Chemistry A, vol. 11, (2023).
[2]. J. Liu et al., “Water Scarcity Assessments in the Past, Present, and Future”, Earth’s Future, vol. 5, no. 6, pp. 545–559, (2017).
[3]. R. Li et al., “Hybrid Hydrogel with High Water Vapor Harvesting Capacity for Deployable Solar-Driven Atmospheric Water Generator”, Environmental Science & Technology, vol. 52, no. 19, pp. 11367–11377, (2018).
[4]. M. Ehtisham et al., “A Comprehensive Review of Approaches, Systems, and Materials Used in Adsorption-Based Atmospheric Water Harvesting”, Science of The Total Environment, vol. 958, p. 177885, (2025).
[5]. W. Zeng, T. You, W. Wu, “Passive Atmospheric Water Harvesting: Materials, Devices, and Perspectives”, Nano Energy, vol. 125, p. 109572, (2024).
[6]. X. Zhou et al., “Atmospheric Water Harvesting: A Review of Material and Structural Designs”, ACS Materials Letters, vol. 2, no. 7, pp. 671–684, (2020).
[7]. M. Bilal et al., “Adsorption-Based Atmospheric Water Harvesting: A Review of Adsorbents and Systems”, International Communications in Heat and Mass Transfer, vol. 133, p. 105961, (2022).
[8]. S. N. Abd Elwadood et al., “Aluminophosphate-Based Adsorbents for Atmospheric Water Generation”, Journal of Water Process Engineering, vol. 49, p. 103099, (2022).
[9]. H. Shan et al., “Exceptional Water Production Yield Enabled by Batch-Processed Portable Water Harvester in Semi-Arid Climate”, Nature Communications, vol. 13, no. 1, p. 5406, (2022).
[10]. M. Ejeian et al., “Solar Powered Atmospheric Water Harvesting with Enhanced LiCl/MgSO4/ACF Composite”, Applied Thermal Engineering, vol. 176, p. 115396, (2020).
[11]. N. Ortiz, S. Rao, “Review of Rain and Atmospheric Water Harvesting History and Technology”, Oxford University Press, (2024).
[12]. J. Yan et al., “A Polyzwitterionic@MOF Hydrogel with Exceptionally High Water Vapor Uptake for Efficient Atmospheric Water Harvesting”, Molecules, vol. 29, p. 1851, (2024).
[13]. Y. Hu et al., “Ferrocene Dicarboxylic Acid Ligand-Exchanged Hollow MIL-101(Cr) Nanospheres for Solar-Driven Atmospheric Water Harvesting”, ACS Sustainable Chemistry & Engineering, vol. 10, (2022).
[14]. J. Mrowiec-Bialon et al., “Effective Inorganic Hybrid Adsorbents of Water Vapor by the Sol–Gel Method”, Chemistry of Materials, vol. 9, pp. 2486–2490, (1997).
[15]. J. Mrowiec-Bialon et al., “Water Vapor Adsorption on the SiO2–CaCl2 Sol–Gel Composites”, Langmuir, vol. 15, pp. 6505–6509, (1999).
[16]. H. Yang et al., “Temperature-Triggered Collection and Release of Water from Fogs by a Sponge-Like Cotton Fabric”, Advanced Materials, vol. 25, no. 8, pp. 1150–1154, (2013).
[17]. B. Wang et al., “Recent Advances in Atmosphere Water Harvesting: Design Principle, Materials, Devices, and Applications”, Nano Today, vol. 40, p. 101283, (2021).
[18]. D. Zhu et al., “Experimental Study on Composite Silica Gel Supported CaCl2 Sorbent for Low Grade Heat Storage”, International Journal of Thermal Sciences, vol. 45, no. 8, pp. 804–813, (2006).
[19]. S. Shervani et al., “Simultaneous Impregnation and Microencapsulation of CaCl2 Using Silica Gel and Methyl Cellulose for Thermal Energy Storage Applications”, Scientific Reports, vol. 14, no. 1, p. 7183, (2024).
[20]. S. Alsaman et al., “Characterization and Cost Analysis of a Modified Silica Gel-Based Adsorption Desalination Application”, Journal of Cleaner Production, vol. 379, p. 134614, (2022).
[21]. Kozik V. V. et al., “Preparation of CaO@TiO₂–SiO₂ Biomaterial with a Sol–Gel Method”, ACS Omega, vol. 5, pp. 27221–27226, (2020).
